Why does my mix sound bad on a phone? 5 fixes
A mix sounds bad on a phone because the phone's tiny speaker plays almost nothing below about 200 Hz and plays close to mono. Whatever your mix keeps only down low or only out wide disappears, and what's left is the mids, where every harsh spot shows.
That's the short answer. The rest of this guide shows you how to hear the problem in your studio and fix it, so your track holds up on a phone and still sounds right on big speakers.
What a phone does to your mix
A phone changes three things at once:
- The lows are gone. The speaker is too small to move enough air for a kick's thump or a bass note. The exact point changes from phone to phone, but below about 200 Hz you hear very little.
- The width is gone. Many phones have two speakers, but they sit a few centimetres apart, so what reaches you is close to mono: left and right added into one.
- The mids are all that's left. With the lows missing, the middle of your mix carries everything, and anything sharp in it stands out.
So a mix that sounds full in your studio can turn into a thin, sharp one with no bassline. The mix didn't change. The phone only shows you one part of it.
Fix 1: Hear what the phone hears, in your studio
Walking to your phone after every change is slow. Build a rough copy of the phone on your master channel:
- Add an EQ with a steep high-pass filter (it removes everything below the point you set) at 200 Hz.
- Switch the master to mono.
- Turn your speakers down low.
Now load a released song in the same style as yours, at the same loudness, and play it through the same filter. Switch between the two every few seconds.
Listen for what the released song keeps and yours loses. Can you still follow its bassline? Does its kick still mark the beat? That gap is your to-do list.
Turn the filter off before you export. The full method for comparing is in our guide on how to use reference tracks for mixing.
Fix 2: Make the bass heard above 200 Hz
A bass note is more than one low tone. A note at 50 Hz also sounds at 100, 150, 200, 250 Hz and up. Those higher tones are its harmonics.
A phone can't play the 50 Hz. It can play the harmonics, and your ear uses them to follow the note. A bass with strong harmonics stays in the song on a phone. A pure sub bass, which is almost only the low tone, vanishes.
Three ways to give your bass harmonics:
- Add saturation. It's a gentle distortion that adds higher tones on top of the note. Raise it until you can follow the bassline through your phone filter, then stop.
- Layer the same notes one octave up. Keep the layer quiet. On big speakers you hardly notice it. On a phone it becomes the bass.
- Pick a richer sound. If the bass is a plain sine wave, try a sound with more edge playing the same notes.
Fix 3: Give the kick a click
A kick has two parts: the low thump, and the short click at the very start of each hit. The thump sits far below what a phone plays. The click sits in the upper mids, so the phone plays it well.
If your kick disappears on a phone, the click is too weak. Try one of these:
- If there's a compressor on the kick, slow its attack (how fast it turns the sound down after a hit starts), so the front of the hit gets through.
- Layer a short, bright hit on top of the kick, kept quiet.
- With an EQ, sweep a small boost through the upper mids of the kick until you hear the click step forward, and leave it there.
Check through the phone filter. You're done when you can tap along to the kick with the lows removed.
Fix 4: Check what happens in mono
Some stereo effects make a part sound wide by making the left side different from the right. When a phone adds left and right together, those differences can wipe each other out. The part gets quieter, and sometimes it almost disappears.
Switch your master to mono and listen for anything that drops away.
- A widened synth or pad gets much quieter: turn the widening effect down until the part survives in mono.
- A lead vocal or main melody loses level: keep it in the centre, with no widening on it.
- You still want width: record or program two different takes of a part and move one left and one right. Two real parts stay audible in mono.
Fix 5: Tame the mids the phone exposes
On big speakers, the lows cover small problems in the middle of a mix. A phone removes that cover.
The ear is most sensitive between roughly 2 and 5 kHz, which is where vocals, cymbals and bright synths can turn sharp. Through your phone filter, compare that range with your reference song.
If yours is sharper, find the part that hurts and make a small, narrow EQ cut on that part alone. A cut on the whole mix would dull everything else too.
If your mix sounds thin on every speaker, not only on a phone, the cause is different. Start with why a mix sounds thin.
Get an expert's ears on your track
Try our community, Music Production Mastery, free for 7 days. You get a 30-minute call with one of our experts, every premium plugin and app, and our weekly live masterclass.
Start my free weekJoin free now, and stay if you love it.
How to check you fixed it
Three quick tests:
- The bassline test. Through the phone filter, you can hum along with the bass.
- The mono test. In mono, no main part drops away.
- The real phone test. Play your track and your reference song on your phone, one after the other, at the same volume. Yours should not sound smaller or sharper.
If one test fails, go back to the fix it points to: Fix 2 for the bass, Fix 4 for mono, Fix 5 for sharpness.
Don't mix for the phone alone
Never boost the lows to make a phone play them. It can't, and the boost will make the track boom on every bigger speaker.
That's how the loop starts: you fix the phone and break the car, then fix the car and break the studio. Every fix in this guide adds something the phone can play and leaves the big-speaker sound in place, so each one holds on every system.
The way out of the loop for good is hearing the three things a pro hears separately in every mix: frequency balance, dynamics and stereo image. A phone strips a mix down to the middle of its frequency balance, in mono. Once you can hear that middle as its own thing, you know how a mix will sound on a phone before you ever pick one up.